The blade is further assembled with these pins along its length and glued in place with the same epoxy, held in compression with the threaded rod and a nut until dry. The tip of the blade has a threaded insert (McMaster Carr 92395A116) installed to hold a 1/4"-20 threaded rod (McMaster Carr 94210A168). The split halves of all of the major parts (blade, pommel, hilt and guard) were assembled with small pins for alignment (McMaster Carr 98381A469) and two-part, 5-min epoxy (Loctite Quickset). This was created based on the artwork from Skyward Sword as well as the statue that came with the collector's edition of BotW and a pair of dial calipers, then scaled to human size. ![]() ![]() This is my rendition of the Master Sword from the most recent Legend of Zelda games (Skyward Sword & Breath of the Wild).
0 Comments
Leave a Reply. |